You can then take the wax strip off to expose the adhesive strip and attach it to the control board. You can do that by inserting the pliable circuit that is on the membrane into the opening that is on the control board. Once the old membranes are off the control board, you’ll need to replace them. Once the control board has heated up, you should be able to peel the membrane off the control panel (start with the top membrane, and then do the other one using the same process). Just be careful it doesn’t get too hot – this is best achieved by using the lowest setting on the dryer. This can be done by using a hairdryer to apply heat to the control board for about 20 to 30 seconds. Once the control board is removed from the microwave, you need to remove the membranes from the control board. Step 5 – Remove the membranes from the control board You should be able to lift the control panels up and out from the microwave. Once the screws are removed, you need to remove the screw that holds the green ground wire in place and then remove the wires that are connected to the control panel. You can do that by locating and then unthreading the screws that keep the control panel attached to the microwave frame. The next step is to remove the control panel. Once the screws are removed, the grille should just pop off. You can do that by locating the 2 screws that attach the grille to the microwave and unthreading them with a Phillips-head screwdriver. Once you have turned the power off and have the microwave on a table or bench, the next step is to remove the grille. You’ll want to put it down on a flat table or bench to make taking it apart easier. You can then pull the microwave out from the cabinet or take it off its mounting bracket so you can work on it. Unplug your microwave from the power socket. If not, you’ll need to move on to step 2 – but only if you have the tools and knowledge to repair a microwave. Once you turn it back on, check if the error code has gone. To reset your microwave, simply switch it off, wait a few minutes, and then turn it back on again. This is because sometimes microwaves can show error codes by mistake. Sometimes a simple reset will solve the problem and remove the error code. SCA1001KSS02 Step 1 – Reset your microwave This guide covers the following GE microwave models: If you don’t have experience working with appliances, try to reset your microwave (see below), and if that doesn’t work, call a qualified technician to come and look at your microwave or take it into an appliance repair shop. Please note that repairing microwaves is very dangerous due to the risk of electric shocks you should never attempt any repairs unless you are experienced working with dangerous appliances. Most of the time this means it has shorted out, so you’ll need to take your microwave apart and fix it. The F3 error code means you have a problem with your keypad. In this article, we will give you step-by-step instructions on how to find the cause of the error code and fix it so you can start using your microwave again. If your GE microwave is displaying an F3 error code, you’re in the right place.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |